切片 切片 切片 切片 切片 切片 切片 切片 切片 切片 切片 编组 3 切片 切片 路径 2 download 工具 配置对比 手册 切片 切片
VNX for File启用FC端口时提示“Error 14: The Block Enabler is not present, it is required for this upgrade to proceed”
2013-02-26知识编号:094943
催更新
故障现象:

输入以下命令时,有如下报错:


# /nas/sbin/nas_hw_upgrade -option -enable -mpfsis | -mpfsfc  |  -clariionfc  |  -clariionis  | -fc_option -enable


Checking if running on primary CS...yes


Checking if running as root...yes


Checking for integrated system...yes


Checking if model is supported...yes


Checking if backend is supported...yes


Checking if BlockEnabler is installed...no


Error 14: The Block Enabler is not present, it is required for this upgrade to proceed.


输入以下命令查看,发现该系统为纯File


# /nas/sbin/model -option -list


OPTION ENABLED: NOT AVAILABLE  -->说明是File Only


原因分析:

VNX File Only 不能添加FC启用标志,也不能用“nas_hw_upgrade”命令添加任何硬件升级标志,必须从File Only升级到Unified才可以。


解决方案:

使用USM导入Unified的NDU License或是通过命令行导入Enabler,将File Only升级成Unified即可。


例如:


# /nasmcd/sbin/navicli –h <sp_ip>  ndu –messner –install -UnisphereBlock


0
知识有用,就点一下~
0
收藏 :
分享 :

鐢ㄦ埛鍚嶄笉姝g‘

鐧诲綍
鍏朵粬鐧诲綍鏂瑰紡

鎵撳紑鑱旀兂鏅洪€堿pp鎵爜杩涜鐧诲綍

鎵弿鎴愬姛!

璇峰嬁鍒锋柊鏈〉闈紝鎸夋墜鏈烘彁绀烘搷浣滐紒

浜岀淮鐮佸凡澶辨晥
鍒锋柊
当前网络不佳, 请刷新重试
图片加载中...